Ribbon Weaving Baby Card              by Madeleine
To make this card you will need:

You will also need a craft knife and cutting mat
Instructions:

Step 1
Cut a piece if Ice Silver card to 110mm x 110mm square
Step 2
Measure 2 cm from the edge with a ruler and draw a line with a pencil.  Do this on all 4 edges.
*Tip: each square of the Carl Cutting Mat is exactly 1 cm so simply line the edge of your piece of card up with one of the lines the on the cutting mat and count 2 lines in then line up your ruler for a perfect 2 cm edge.
Step 3 Using a craft knife and a cutting mat cut out the aperture in the Ice Silver card marked by the pencil lines.

*Tip: Line up your pencil lines with one of the lines on your cutting mat.  Then line up your metal ruler with the same line for precision cutting.
Step 4
Apply 6mm double-sided tape to the left had side edge, the top edge, and the bottom edge keeping close to the aperture.  Peel the backing tape from the double-sided tape on the left hand edge and top edge tape only.  Do not peel the backing from the double-sided tape at the bottom of the aperture.
Step 5
Cut 10 strips of white double-sided satin ribbon in approx. 100mm lengths.
*Tip:  Measure the first strip and then use that as the guide when cutting the remaining 9 strips.

Step 6 Lay them against the double-sided tape on the left hand side of the aperture.

Step 7 Cut 10 strips of blue double-sided satin ribbon in approx. 100mm lengths.

Step 8 Lay them against the double-sided tape on the top side of the aperture.
Step 9 Starting with the top strip of white ribbon, and working from left to right, weave the white ribbon with the blue ribbon weaving over the first and under the next until you reach the right jand edge of the aperture.  Keeping the white ribbon taut, and trimming any excess if necessary, glue in place using a tiny piece of double sided tape.
Step 10 Now take the next strip of white ribbon and this time weave it with the blue ribbon weaving under first and then over until you reach the right and side and fix into place.
Step 11 Keep working down the strips of white ribbon alternating the weaving over and unders until all the strips of white ribbon are woven into the blue ribbon and fixed in place.

Step 12 Finally, trim the blue ribbon if necessary, then slowly peel the backing from the double-sided tape on the bottom edge of the aperture, and making sure that the blue ribbon is straight and taut, glue each piece of blue ribbon to the white card as you peel.
Step 13 Attach double-sided foam tape to the edges of the ribbon weaved card and glue in place on the Vista card.
Step 14 Add your embellishments..
                         
 
                      http://www.craftsite.co.uk/gallery/id84.htm