Card Making Project - Copper Butterflies Wedding Invitation
Made by Linda
This card uses the Cuttlebug and the foiled Wedding Invitation in copper.

To make this card you will need:

Cut the Stardream Copper card, using the deckle blade or deckle edge scissors, to 90mm x 80mm.  

Run the cut piece of Stardream Copper card through the Cuttlebug using the daisy  pattern embossing folder then glue to the Europa Ivory creased card using double-sided tape or photo glue (depending on how confident you are about positioning it right on the first go).

Using either double-sided tape or photo glue the Wedding Invitation foiled card and glue to the centre of the Stardream Copper card.

Using the Cuttlebug and the 2 step butterfly die, cut 2 solid butterflies out of Stardream Copper card and 2 butterfly outlines out of Europa Ivory card.  Glue to the outline to the solid butterfly using either white craft glue or a glue pen.
Note: the glue pen is easier but the white craft glue will give a firmer hold.  With fine items such as the butterfly outline it is better if you put a little of the craft glue into an egg cup and apply the glue with a paintbrush.

Put 4 dots of crystal stickles on each of the butterfly wings.

Attach the butterflies to the card using 3D foam pads.