Card Making Project - A5 Dufex Snowman Card Made by Madeleine
		This card is the last in our series of making 3 totally different cards from the 1 Dufex Decoupage Sheet. To make this card you will need: A4 Stardream Sapphire Card creased to A5 Gold Foiled Card cut to 125mm x 103mm Stardream Opal Card cut to 115mm x 93mm Stardream Copper Card cut to 105mm x 83mm Strip of Gold Mirror Card cut to 148mm x 20mm Dufex Die Cut Decoupage Snowmen Silver Peel Off Happy Christmas - the one used here is from the Glitter Peel Off sheet. Dufex Brush Pens Set 1 Photo Glue 3D Foam Pads or Silicon Glue Corner Rounder Punch CarlaCraft Deckle Edge Scissors or Carl Cutter or DC-212 or PRT-100 Trimmer and Deckle Blade.
To create the deckle edge on the card trim 2mm on the edge of the Stardream Sapphire card using the deckle decorative scissors or the deckle blade. Push out and make up the Dufex decoupage using foam pads or silicon glue.   Using the corner rounder punch round each corner on the larger piece of gold foiled card, the Stardream Opal card and the Stardream Copper card. Mat and layer by gluing the Stardream Opal card to the gold foiled card, then the Stardream Copper card to the Stardream Opal card using photo glue allowing about 30 seconds between each layer for the glue to dry. Glue the decoupage to the Stardream Copper card using photo glue and leave to dry.  Then, again using photo glue, position and flue down the matted layers and decoupage onto the Stardream Sapphire card. Using the dark blue Dufex brush pen colour the peel off you are going to use for the greeting.  Leave to dry for several minutes. Take the 148mm x 20mm piece of gold foiled card and trim each side using the deckle decorative scissors or deckle blade so that the length of the foil card is approx. 138mm.   Check that the coloured peel off has dried then place in the centre of the gold foil strip and attach the gold foil strip to the Stardream Sapphire card using photo glue.